Washington – Newly released draft guidance an OSHA advisory committee recommends that staffing firms and host employers implement a safety and health program describing the responsibilities of both entities to protect temporary workers.

Washington – As part of its Temporary Worker Initiative, OSHA has released guidance documents intended to clarify training requirements and hazard communication responsibilities for employers of temporary workers.

Olympia, WA — A new Washington state law will require construction and manufacturing employers who use temporary workers to identify and document workplace hazards, communicate those hazards to staffing agencies, and make sure workers are informed and properly trained.

Washington — NIOSH and the American Staffing Association have announced a multiyear partnership agreement to advance protections for temporary workers.

Washington — NIOSH, together with several partners, has developed a set of best practices to help employers protect temporary workers from injury and illness.

Washington — Federal lawmakers are divided down party lines over a proposed rule from the National Labor Relations Board that would restore the board’s previous definition of “joint employer.”

Washington — The Department of Labor has issued a final rule that targets “employee misclassification” of workers as independent contractors.

Washington — The Federal Motor Carrier Safety Administration is increasing the area safety technology may be mounted inside commercial motor vehicles and expanding the definition of “vehicle safety technology.”

Washington — The Federal Motor Carrier Safety Administration is seeking comment on potentially expanding a program intended to determine to what extent crashes involving commercial trucks and buses are preventable.

The Deluxe Welding Shield is a lightweight (less than 14 ounces) full-size helmet that covers the wearer’s head, neck and ears.

In combination with the MSA V-Gard Protective Cap, the VoltCap offers maximum protection against arc flash.

Cementex Hundred Series Arc Rated Face Shields have changed from green to gray.

The V2 Shield is designed to protect workers from the coronavirus that causes COVID-19. The shield features 91% optical transparency and measures 32 centimeters by 22 centimeters, with a thickness of 0.3 millimeters.

PROTECTOR Shields defend machine operators from flying debris, lubricants, coolants and swarf. They’re constructed from 14-gauge powder-coated steel and thick 3/16-inch shock-proof, scratch-resistant polycarbonate.

This lift-front hood, part of the Ultralight Series of Arc Flash PPE, offers wearers a larger viewing area through a clear gray color faceshield.

Falls Church, VA – The average salary for industrial hygienists has increased more than $10,000 in the past five years, according to survey results released May 30 by the American Industrial Hygiene Association.

TrustFit Pod Push-In Foam Earplugs provide workers with properly fitting earplugs to protect against noise-induced hearing loss.

Using recent data and analysis from NIOSH, the Workers Compensation Research Institute and other organizations, Safety+Health presents an infographic showing the impact of the opioid crisis on the workplace.

Austin, TX — The Texas Department of Insurance’s Division of Workers’ Compensation has published a plain language glossary intended to make workers’ comp insurance easier to understand.

Hartford, CT — More than a third of work-related injuries occur during people’s first year on the job – resulting in more than 6 million missed workdays, according to a new report.

Power Pusher has expanded the capabilities of its durable Super Power Pusher with a dual-motor model capable of moving up to 250,000 pounds for enhanced productivity that simultaneously reduces safety risks.

Lightweight and nylon-lined, CC9009 and CB9009 gloves are 100% polyurethane coated and washable, ideal for ambulance drivers, nursing home workers and police officers, among others.

In non-medical consumer and industrial situations, it’s often advantageous to wear ultrafine nitrile-coated washable gloves, such as the multi-use Aquila NR18E.

These portable and vehicle-mounted handwashing stations allow water and hand sanitizer to be dispensed virtually anywhere.

GL3000 series arc flash protection gloves are available in two new models – GL3009CKB and GL3010CK. They’re designed to provide comfort, fit, dexterity and premium protection. Using the ASTM F2675 test method, both models offer protection against Category 4 arc flashes and are deemed fire resistant under section 8.8 of NFPA’s 2112 standard.

The Power Grid FR 1/4 Zip Dual Hazard Shirt is constructed with Power Grid four-way stretch fabric that offers superior comfort and range of motion.

Offer employees the ultimate flame resistance and insect protection with the men’s 5.8-ounce Tecasafe FR Uniform Shirt.

The 5.5-Ounce Dress Uniform Shirt offers wearers a cutting-edge, lightweight and breathable alternative to legacy FR garments.

How should the NIOSH lifting equation be used?

Two 35-year-old workers using floor sanders were killed and two others were seriously burned in a house fire after the lacquer floor sealer they were using ignited.

Tumwater, WA — A proposed update to Washington state’s permanent rules on worker heat exposure would set the “temperature action level” at 80° F for most outdoor workers.

Carson City, NV — Recently introduced legislation in Nevada would provide outdoor workers with additional protections against extreme heat and poor air quality.

Washington — OSHA has launched a national competition for the best tools and resources on the dangers of heat exposure – indoors and outdoors – at work.

Washington — The National Advisory Committee on Occupational Safety and Health has scheduled a public meeting for May 31.

Washington — OSHA has scheduled a free webinar on its Beat the Heat contest.

Washington — An OSHA standard aimed at protecting workers from extreme heat exposure could prevent at least 50,000 injuries and illnesses annually, a watchdog group contends.

Washington — OSHA’s proposed rule on protecting workers from extreme heat exposure in indoor and outdoor settings is progressing toward potential publication – and the agency wants feedback.

Washington — A group of Democratic lawmakers is pressing OSHA for the “fastest possible implementation” of a standard on protecting workers from extreme heat exposure.

Arlington, VA — The Mine Safety and Health Administration is reminding mine operators of best practices for preventing heat stress and treating workers who become overheated.

Washington — OSHA is asking representatives from small businesses, as well as local governments and nonprofit organizations, to weigh in on how a standard to protect workers from heat illness would affect small entities.

Washington — A new OSHA fact sheet and sticker are intended to raise awareness of heat illness prevention strategies in the workplace.

Washington — OSHA has announced the winners of its national competition challenging stakeholders to submit the best tools and resources on the dangers of heat exposure – indoors and outdoors – at work.

Washington — OSHA says it’s allowing more time for stakeholders to comment on a proposed rule aimed at protecting workers from extreme heat exposure in indoor and outdoor settings.

Washington — OSHA has published a new resource on how best to protect pregnant workers from heat-related illnesses.

Washington — Certain personal risk factors increase workers’ risk for heat-related injury and illness, OSHA cautions.

Washington — Two potential OSHA regulations will be discussed during an upcoming Advisory Committee on Construction Safety and Health meeting.

Washington — OSHA’s Advisory Committee on Construction Safety and Health has unanimously recommended that the agency move forward with its proposed standard on protecting workers from excessive heat.

Washington — OSHA’s national competition to raise awareness of the dangers of heat exposure is back with a new element – a photo contest.

Washington — A wallet card, brochure and checklist are recent additions to OSHA’s resources for helping keep workers safe in high temperatures.

Washington – OSHA recently issued a fact sheet about protecting workers from abrasive blasting materials.